Table of Contents
Advertisement
9
Install and configure LDS
The PRIMES LDS can be installed on the PC to operate the measuring devices. The LDS controls the
measurements and returns the measurement results in graphical form. The PRIMES LDS is available on the
PRIMES website at: https://www.primes.de/de/support/downloads/software.html.
The measuring device can be operated directly via the system without the LDS. For this, read on from
chapter 11 „Measurement settings" on page 47.
9.1
System requirements
Operating system:
Processor:
Required hard disk space:
Monitor:
LDS version:
9.2
Install software
The software is installed menu-driven. Start the installation by double-clicking on the file „Setup LDS v.2.98.
exe" and follow the instructions.
Fig. 9.1:
LDS Setup
Unless otherwise specified, the installation software writes the main program "LaserDiagnosticsSoftware.exe" to
the "Programs/PRIMES/LDS" directory. In addition, the settings file „laserds.ini" is also copied to this directory.
The setting parameters for the PRIMES measuring devices are stored in the „laserds.ini" file.
38
Windows
7/10
®
Intel
Pentium
1 GHz (or comparable processor)
®
®
15 MB
19" recommended screen size, resolution min. 1024x768
2.98
FocusParameterMonitor FPM
Revision 06 EN 02/2023
Advertisement
Table of Contents
