Table of Contents
Advertisement
About this operating manual
Further icons and conventions in this operating manual
Here you will find useful information and helpful tips.
Indicates a single instruction.
If several of these instructions appear one below the other, the order in which they are executed is
irrelevant or they represent alternative courses of action.
1.
2.
A numbered list identifies a sequence of instructions that must be executed in the specified order.
...
Indicates the result of an action to explain processes that take place in the background.
Indicates an observation prompt to draw attention to visible feedback from the device or the software.
Observation prompts make it easier to check whether an instruction was executed successfully.
Often they also guide to the next instruction.
Points to a control element that is to be pressed/clicked.
Points to an element described in the text (for example an input field).
3
About this operating manual
This manual describes working with the FocusParameterMonitor FPM and its settings both
•
via a system using a PLC
•
as well as with the LaserDiagnosticsSoftware LDS 2.98.
The FocusParameterMonitor FPM is intended to be used with a PLC for fully automated operation. Manual
operation with a PC is not recommended.
However, since the FocusParameterMonitor FPM is designed for measuring short-term exposure and does
not automatically adjust the exposure time, the appropriate exposure time must be determined for the
various beam configurations. The LaserDiagnosticsSoftware LDS 2.98 can be used for setup.
The LaserDiagnosticsSoftware LDS 2.98 is available free of charge on the PRIMES website at:
https://www.primes.de/de/support/downloads/software.html.
In these operating manual, the abbreviations FPM and LDS will be used in the following.
Revision 06 EN 02/2023
9
Advertisement
Table of Contents
