Table of Contents
Advertisement
Install and configure LDS
9.3.4
Obtain an IP address automatically with DHCP
DHCP (Dynamic Host Configuration Protocol) enables a device to be automatically integrated into an existing
network without manual configuration.
Activate the DHCP function in the LaserDiagnosticSoftware with the command: se0332
(The „
" in the command represents a space.)
1. Start the LDS.
2. Open the Communication > Free Communication dialog window.
3. In the Mode field, select TCP (the Second IP option must not be activated!).
4. In the TCP field, enter the current IP address.
5. Click the Connect button ("Connected" appears in the bus monitor).
6. Check the Write bus protocol box (the protocol can be very useful when encountering problems):
•
The log is stored in the installation directory of the LDS.
•
The file name is buspro.log.YYYY.MM.DD (YYYY.MM.DD = date the file was created).
7. Enter the following command in the Command input field: se0332
8. Click on the Send button and wait for the confirmation in the bus monitor
(see Fig. 9.4 on page41 „- > Adr:0332 Wert: 001")
9. Turn the device off and on again.
-- Connecting to Device ip 192.168.116.85 port 6001...
--CONNECTED to 192.168.116.119.6001
<-se0332 001
- > Readback o.k.
- > ReadingEEPROM into structure...
- > Calculating structure CRC...
- > Storing structure CRC to EEPROM...
- > Adr: 00332 Wert
Fig. 9.4:
Enable DHCP in the Free Communication dialog box
After restarting the device in the network, a new IP address is requested and automatically assigned by the
server/router. The FindIP function via the MAC address cannot be executed in this case.
If there is no connection to the network (no response from the server), the static IP address (see type plate) is
activated in the FPM until it is restarted again.
The DHCP function can be disabled with the command se0332
Revision 06 EN 02/2023
192 . 168 . 116 . 119
se0332 001
001
001
Confirmation
P
000.
001
Bus protocol
41
Advertisement
Table of Contents
