Adjustment Of Clearance Between The Transfer Drum Joint And Paper Separator Guide - Minolta CF910 Service Manual

(6) Adjustment of Clearance Between the Transfer Drum Joint and Paper
Separator Guide
Adjusting Screw
Flat Surface in Joint
Guide
Adjustment Procedure
1. Turn the Transfer Drum so that the center (flat surface) of the joint is located under
the guide.
2. Align the Transfer Adjusting Jig with the rear double-sided adhesive tape on the
Transfer Film as shown above. Loosen the adjusting screw, push the Paper Separa-
tor Finger Solenoid with a finger in the direction of the arrow as far as it will go, then
tighten the screw.
Clearance Between Joint and Guide Tip
3. Check again for correct clearance at the measurement point using the Transfer
Adjusting Jig as shown below.
Guide Roll
Guide
Transfer Film
Joint
Good
Transfer Adjusting Jig
D-143
Direction of Transfer
Drum Rotation
Measurement Point
Double-Sided Adhesive Tape
No good
1144D329AA
Measurement
Point
1154D283AB
1.0 ±0.25 mm
1154D272AA