Minolta CF910 Service Manual page 341

Service Mode Menu
Touch Panel Display
Jam Sensor
Feed Motor Speed Use this function to vary the speed of the Paper Take-Up Motor
PRT Area
Top-Margin
Image Start
Position
Lead Edge
Position
Left Margin
Dup.
Left Margin
Machine Adjust
Use this function to adjust the sensor output voltage for Paper Bond-
ing Failure Detection Board 1 PWB-01 and Paper Bonding Failure
Detection Board 2 PWB-02.
according to the type of paper to be used.
-80 -70
Slower
Use these functions to adjust on the printer the positional relation
between the paper and image in the main and sub scanning direc-
tions, respectively.
Adjust the relation in the sub scanning direction for the following two
parameters.
Adjust the image leading edge position by varying the print start posi-
tion of the printer.
-3.5mm -3.4
Narrower margin width
Note
The position is variable in 0.1-mm steps.
Adjust the image leading edge position by varying the position at
which paper sticks to the Transfer Drum (i.e., image transfer position).
-5.0mm -4.9
Narrower margin width
Note
The position is variable in 0.1-mm steps.
Adjust the image position for each paper source by varying the print
start position of the printer in the main scanning direction.
-5.0mm -4.5
Narrower margin width
Note
The position is variable in 0.5-mm steps.
Adjust the image position of each paper source in the 2-sided Mode by vary-
ing the print start position of the printer in the main scanning direction.
-5.0mm -4.5
Narrower margin width
Note
The position is variable in 0.5-mm steps.
Setting
... 0 ...
... ±0 ...
... ±0 ...
... ±0 ...
... ±0 ...
S-28
+60 +7.0
Faster
+3.4 +3.5mm
Wider margin width
+4.9 +5.0mm
Wider margin width
+4.5 +5.0mm
Wider margin width
+4.5 +5.0mm
Wider margin width