Cf910 To Cf911P Changes List - Minolta CF910 Service Manual

1. CF910 to CF911P Changes List

1-1. The CF911P does not contain the following CF910 parts (Electrical Parts List).
LA1 Exposure Lamp
M1 Scanner Motor
M2 Original Glass Cooling Fan Motor
M24 IR Cooling Fan Motor 1
M25 IR Cooling Fan Motor 2
PC1 Scanner Home Position Sensor
PC2 Original Cover Angle Detection Sensor
PU2 DC Power Supply 2
PWB-A CCD Sensor Board
PWB-B A/D Converter Board
PWB-G Motor Drive Board
PWB- Tech. Rep. Setting Switches Board
SE1 Original Size Detecting Sensor 1 (OP)
SE2 Original Size Detecting Sensor 2
SE3 Original Size Detecting Sensor 3
SE4 Original Size Detecting Sensor 4 (OP)
1-2. The following part has been changed.
UN27 From CF910 Control Panel to CF911P Operation Panel.
1-3. The CF911P includes the new parts listed below.
FIERY X2E
PWB-E
1-4. General manual changes.
1. Change the Touch Panel to the Control Panel and/or PC screen.
2. Change the Malfunction Reset switch to the Trouble Reset key on the panel that
appears in "Clear Mode" on the PC screen.
3. Image stabilization problem indicator is not applicable.
4. Security Mode is not applicable.
5. Additional Notes:
•
When the power is switched on but the CF911P does not display "Ready," switch
the power Off and On again.
•
When the Message "Alert, Service Code" is displayed, press the down key, display
the Error Code on the second line.
Printer Controller Board
Controller Interface Board
-2-
D: DisReassembly/Adjustment