Minolta CF910 Service Manual page 337

Setting Mode Menu
Touch Panel Display
DT setting
Initial
Transmission
Data Save/Load
Data Save
Data Load
Call Completion
Spare Counter
Clear
Marketing Area
Manual Paper
Width
Org. Detect
Sensor
Serial # Input
RD Mode
Setting (the default setting is
--------------------------------------------------------
Used to perform the initial transmission from the PPC to the Center to
check for correct communication when the Data Terminal has been
set up.
Enables the transmission of Data Save and Data Load.
Transmits the command that saves the PPC RAM data to the Center.
Transmits the command that loads the data sent by Data Save back
to the PPC.
Used by the Tech. Rep. to notify the Center that his/her service job for
the copier has been completed.
Used to clear the count of the spare counter set by the Center.
Select the marketing area which determines the paper size and fixed
zoom ratio settings.
MJ
Use this function to automatically adjust the paper reference position
of the Multi Bypass Table.
<Adjusting Procedure>
1. Select "Maximum Size," place several sheets of A3 Wide or 12" ×
18" paper on the Multi Bypass Table, and press the Start key.
2. Select "Minimum Size," place several sheets of B5 lengthwise or
5-1/2" × 8-1/2" lengthwise paper on the Multi Bypass Table, and
press the Start key.
Select "Set" when the optional Original Size Detecting Sensors are
installed.
Set (When sensors are
installed)
Enter the serial number of each system component including options
from the 10-Key Pad.
MC
Unset
not installed)
S-24
Highlighted
)
MH
(When sensors are