Installation Proposal - Edwards EOSi Series Instruction Manual

1. 1.
Table 18 Centre of gravity and weight
Type
EOS 1300(W)i
EOS 1600(W)i
EOS 1900(W)i
EOS 1300Q(W)i
EOS 1600Q(W)i
* Dimensions: ± 50 mm or ± 2 inches
# Approximate weight ±20 kg or ±44 lbs

6.2 Installation proposal

Install the pump on a level surface that:
▪ is clean
▪ is vibration free
▪ has sufficient lighting
▪ is ventilated
▪ supports the weight of the pump.
The complete length of the frame base must be supported. Add a shim where it is
necessary. Do not use wood.
Make sure that the ambient temperature is not more than the specified temperature.
All models are intended for indoor installation.
Do not locate the pump where the hot exhaust air from other pumps or heat generating
equipment can be drawn into the pump. Never prevent the flow of exhaust air from the
fluid cooler.
Release the hot exhaust air outside to prevent the high ambient conditions in the room.
6996022910_B
6996022910_B - Installation
Centre of gravity*
X mm (inch) Y mm (inch)
651 (25.63) 697 (27.44)
Page 75
Weight
Z mm (inch) Kg (lbs)
637 (25.07) 1058 (41.65)
655 (25.78) 1058 (41.65)
673 (26.49) 1073 (42.24)
655 (25.78) 1058 (41.65)
673 (26.49) 1073 (42.24)
09/2021 - ©Edwards Limited
#