Figure 20 Air filter
1. Air filter (AF)
1. Air filter (AF)
3. Air filter (GBF)
3. Air filter (GBF)
9.5 Oil and oil filter change
WARNING: OIL CONTAMINATION
Risk of damage to equipment. Always drain the pump oil at all drain points. Used oil
that is not drained from the pump can contaminate the oil system and can decrease
the lifetime of the new oil.
Note:
Do not mix lubricants of different brands or types as they can possibly not be compatible
and the oil mix will have inferior properties. A label, showing the type of oil filled
ex‑factory, is given on the air receiver/oil tank.
To replace the oil and oil filter, do the steps that follow:
1.
Operate the pump until warm and stop the pump.
2.
Close the air inlet isolation valve.
3.
Set the voltage to off.
4.
Vent the pump by opening the plug on the cover of the air inlet filter.
6996022910_B
6996022910_B - Maintenance
Page 104
2. Plug
2. Plug
09/2021 - ©Edwards Limited