3.15 Week timer menu
Menu icon, Week timer
Function
▪
To programme time-based start/stop commands for the pump.
▪
To programme time-based change-over commands for the net pressure band.
▪
Four different week schemes can be programmed.
▪
A week cycle can be programmed. A week cycle is a sequence of 10 weeks. For
each week in the cycle, you can select one of the four programmed week schemes.
Note:
In the controller you can select different timers on one day (up to eight actions). It
is not possible to programme two actions at the same time. Keep minimum of
1 minute difference between each action.
For example, Start pump: 5.00 AM, Pressure setpoint 2: 5.01 AM (or later).
Procedure
Start from the Main screen (refer to
▪
Use the Scroll keys to move the cursor to Menu action button.
▪
Push the Enter key.
▪
Use the Scroll keys to move the cursor to select the Timer icon. The screen that
follows is shown:
1. Menu
1. Menu
▪
Push the Enter key. The screen that follows is shown:
6996022910_B
6996022910_B - Airlogic graphic regulator
Main screen
Page 48
on page 25):
2. Week Timer
2. Week Timer
09/2021 - ©Edwards Limited