Pictographs; Figure 17 Pictographs - Edwards EOSi Series Instruction Manual

6.8 Pictographs

Figure 17 Pictographs

1. Warning, voltage 1. Warning, voltage
3. Motor rotation arrow 3. Motor rotation arrow
5. Warning, loaded spring 5. Warning, loaded spring
7. Stop the pump before the coolers are 7. Stop the pump before the coolers are
cleaned. cleaned.
10. Water out 10. Water out
12. Grease the motor instruction 12. Grease the motor instruction
14. If the rotation direction is wrong, open 14. If the rotation direction is wrong, open
the isolating switch in the voltage supply the isolating switch in the voltage supply
line and reverse the two incoming line and reverse the two incoming
electric lines. electric lines.
6996022910_B
6996022910_B - Installation
Page 82
2. Warning, hot surface 2. Warning, hot surface
4. Set the voltage to off and depressurise 4. Set the voltage to off and depressurise
the pump before you start the the pump before you start the
maintenance or repair. maintenance or repair.
6. Lightly apply oil to the gasket of the oil 6. Lightly apply oil to the gasket of the oil
filter, install it and tighten by hand filter, install it and tighten by hand
(approximately half a turn) (approximately half a turn)
8. Lifting instruction 8. Lifting instruction
9. Water in 9. Water in
11. Manual drain 11. Manual drain
13. Set the voltage to off and wait for 13. Set the voltage to off and wait for
10 minutes before the maintenance is 10 minutes before the maintenance is
started. started.
09/2021 - ©Edwards Limited