Table of Contents
Advertisement
CAUTION: RADIO INTERFERENCE
Risk of injury. In a domestic environment, the pump can cause radio interference
which requires supplementary mitigation measures.
▪
Obey the work safety requirements and regulations.
▪
Obey all the local site safety and operating procedures.
▪
If any of the statements do not match with the applicable legislation, the stricter of
the two statements takes priority.
▪
The personnel responsible for the installation, operation, maintenance and repair
work must be trained and approved by us.
▪
The pump is designed for handling atmospheric air only. Other gases, vapours or
fumes must not be exposed to the pump intake or processed by the pump.
▪
Before you do the maintenance, repair, adjustment or other non-routine checks,
refer to
▪
For units that have a supply from a frequency converter, wait for 10 minutes after
disconnection before you start the electrical work.
▪
Do not rely on the indicator lamps or electrical door locks. Before you do
maintenance work, disconnect and check for electrical safety with a measuring
device.
▪
Do not touch the pump intake when the pump is in operation.
▪
Keep the pump in safe operating condition. Replace parts and accessories that are
not safe for operation.
▪
Do not walk or stand on the pump or on its components.
Note:
1. These precautions apply to a pump that processes or uses air or inert gas. When
the pump is used with other gases, it is necessary to use more safety precautions.
2. Some precautions are general and are applicable for all types of pumps and
equipment. Some of the statements, might not apply to your pump.
3. If the installation, operation, maintenance, and repair is done without our prior
written approval, or if the pump is not installed in accordance with our
recommendations, we will not accept liability or warranty claims in accordance
with the standard terms and conditions.
1.3 Safety precautions during installation
1.
When you lift the pump, make sure that:
▪
▪
▪
▪
▪
2.
The pump is made to be installed and used inside. If the pump is installed outside,
contact us.
3.
Install the pump in an area with cool and clean air.
6996022910_B
6996022910_B - Safety and compliance
Preventive maintenance schedule
you use the correct lifting equipment and you obey the local safety regulations
you tighten all the loose and movable parts before you lift the pump
no personnel are in the risk zone below the lifted load
the speed of the lifting equipment is in safety limits
personnel wear safety helmets in the area of overhead or lifting equipment.
on page 100.
Page 8
09/2021 - ©Edwards Limited
Advertisement
Table of Contents
