Table of Contents
Advertisement
Outdoor/altitude operation
The pumps are designed according to the IP2X classification. The electrical cabinet and
motor are designed according to the IP54 classification. If the pump is installed
outdoors, special precautions must be taken. Contact us.
The pumps can only be used in temperatures above 0 °C (+32 °F). If frost occurs, take
applicable protective steps to prevent damage to the pump and its ancillary equipment.
In this case, contact us.
If it is necessary to operate the pump at more than 1000 m (3300 ft), contact us.
6.5 Position the pump
WARNING: HEAVY OBJECT
Risk of injury and damage to the equipment. Do not lift the pump if the external body
(canopy) parts or lifting supports are not fully installed. When the pump is being
lifted, do not stand below the load or do maintenance.
▪
The pumps can be moved by a lift truck using the slots in the frame. Make sure
that the bodywork is not damaged while lifting or transport of the pump.
▪
Before lifting, install the transport securing bolts.
▪
Make sure that the forks extend to the other side of the frame.
▪
The pumps can also be lifted after you insert beams in the slots.
▪
Make sure that the beams do not slide and extend uniformly from the frame.
▪
Hold the chains parallel to the bodywork by the chain spreaders to prevent
damage to the pump.
▪
Lift the pump vertically.
▪
Carefully lift the pump without twisting.
Figure 15 Lifting slots
6996022910_B
6996022910_B - Installation
Page 78
09/2021 - ©Edwards Limited
Advertisement
Table of Contents
