Safety; Symbols Used; Warnings; Notes On Ce Marking - MICRO-EPSILON interferoMETER Operating Instructions Manual

Safety

1. Safety
System operation assumes knowledge of the operating instructions.
1.1

Symbols Used

The following symbols are used in these operating instructions:
Indicates a hazardous situation which, if not avoided, may result in
CAUTION
minor or moderate injuries.
Indicates a situation which, if not avoided, may lead to property
NOTICE
damage.
Indicates a user action.
i
Indicates a user tip.
Measure
Indicates a hardware or a button/menu in the software.
1.2

Warnings

Connect the power supply and the display/output device according to the safety regulations for
CAUTION
electrical equipment.
> Risk of injury
> Damage to or destruction of the controller
The supply voltage must not exceed the specified limits.
NOTICE
> Damage to or destruction of the controller
Avoid shocks and impacts to the sensor and controller.
> Damage to or destruction of the components
> Never fold the fiber optics and do not bend them in tight radii.
> Damage to or destruction of the optical fibers; failure of measuring device
Protect the ends of the optical fibers against contamination. Use protective caps.
> Failure of the measuring device
Protect the cable against damage.
> Failure of the measuring device
1.3

Notes on CE Marking

The following apply to the interferoMETER IMS5x00:
- EU Directive 2014/30/EU,
- EU Directive 2011/65/EU
Products which carry the CE mark satisfy the requirements of the EU directives cited and the relevant applicable harmo-
nized European standards (EN). The measuring system is designed for use in industrial and laboratory applications.
The EU Declaration of Conformity and the technical documentation are available to the responsible authorities according
to the EU Directives.
IMS5x00 Page 9