Disclaimer; Service, Repair; Decommissioning, Disposal - MICRO-EPSILON interferoMETER Operating Instructions Manual

Disclaimer

9. Disclaimer
All components of the device have been checked and tested for functionality in the factory. However, should any defects
occur despite careful quality control, these shall be reported immediately to MICRO-EPSILON or to your distributor /
retailer.
MICRO-EPSILON undertakes no liability whatsoever for damage, loss or costs caused by or related in any way to the
product, in particular consequential damage, e.g., due to
- non-observance of these instructions/this manual,
- improper use or improper handling (in particular due to improper installation, commissioning, operation and mainte-
nance) of the product,
- repairs or modifications by third parties,
- the use of force or other handling by unqualified persons.
This limitation of liability also applies to defects resulting from normal wear and tear (e.g., to wearing parts) and in the
event of non-compliance with the specified maintenance intervals (if applicable).
MICRO-EPSILON is exclusively responsible for repairs. It is not permitted to make unauthorized structural and / or techni-
cal modifications or alterations to the product. In the interest of further development, MICRO-EPSILON reserves the right
to modify the design.
In addition, the General Terms of Business of MICRO-EPSILON shall apply, which can be accessed under Legal details |
Micro-Epsilon https://www.micro-epsilon.com/impressum/.
For translations into other languages, the German version shall prevail.
10.

Service, Repair

If the sensor, controller or sensor cable is
defective:
- If possible, save the current sensor settings
in a parameter set, see Chap. 6.10, to re-
load them into the controller after the repair.
- Please send us the affected parts for repair
or exchange.
If the cause of a fault cannot be clearly identi-
fied, please send the entire measuring system
to:
11.

Decommissioning, Disposal

In order to avoid the release of environmentally harmful substances and to ensure the reuse of valuable raw materials,
we draw your attention to the following regulations and obligations:
- Remove all cables from the sensor and/or controller.
- Dispose of the sensor and/or the controller, its components and accessories, as well as the packaging materials in
compliance with the applicable country-specific waste treatment and disposal regulations of the region of use.
- You are obliged to comply with all relevant national laws and regulations.
For Germany / the EU, the following (disposal) instructions apply in particular:
- Waste equipment marked with a crossed garbage can must not be disposed of with normal industrial
waste (e.g. residual waste can or the yellow recycling bin) and must be disposed of separately. This
avoids hazards to the environment due to incorrect disposal and ensures proper recycling of the old
appliances.
- A list of national laws and contacts in the EU member states can be found at
https://ec.europa.eu/environment/topics/waste-and-recycling/waste-electrical-and-electronic-equipment-weee_en.
Here you can inform yourself about the respective national collection and return points.
- Old devices can also be returned for disposal to MICRO-EPSILON at the address given in the imprint at
https://www.micro-epsilon.de/impressum/.
- We would like to point out that you are responsible for deleting the measurement-specific and personal data on the
old devices to be disposed of.
- Under the registration number WEEE-Reg.-Nr. DE28605721, we are registered at the foundation Elektro-Altgeräte Reg-
ister, Nordostpark 72, 90411 Nuremberg, as a manufacturer of electrical and/or electronic equipment.
IMS5x00
MICRO-EPSILON Messtechnik GmbH & Co. KG
Koenigbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.com
www.micro-epsilon.com
Page 78