A 6 Telnet; General; A 6.2 Verbindungsaufbau; A 6.3 Error Messages - MICRO-EPSILON interferoMETER Operating Instructions Manual

Appendix | Telnet
A 6 Telnet
A 6.1

General

The Telnet service allows you to communicate with the IMS5x00 from your PC. To communicate with Telnet, you will need
- an existing Ethernet connection between IMS5x00 and your PC,
- the ASCII commands see
A 6.2 Verbindungsaufbau
Starten Sie das Programm Telnet.exe über das Startmenü > Ausführen.
Tippen Sie den Befehl o 192.254.168.150 bzw. der IP-Adresse des Controllers ein.
Fig. 83 Telnet start screen of IMC5400MP
A command always consists of the command name and zero or several parameters that are separated with a space. The
currently set parameter value is reset if a command is invoked without parameters.
The output format is:
<Command name> <Parameter1> [<Parameter2> [...]]
The returned command can be used again without changes for setting the password. After a command is processed, a
line break and a prompt ("->") is always returned. In the event of an error, an error message beginning withExx, where
xx stands for a unique error number, comes before the prompt.
i
If no connection is successfully established after the IP address is sent, send a c to close the connection. Now send
the command o 192.254.168.150 again to establish the connection..
A 6.3 Error Messages
The following error messages may appear:
- E01 Unknown command: An unknown parameter ID was submitted.
- E06 Access denied: This parameter cannot be accessed at the present time. The controller may not be in Expert
mode or the parameter may not be visible due to other settings.
- E08 Unknown parameter: Not enough parameters were submitted.
- E11 The input value is outside the validity range, or the format is invalid: The submitted value is outside the validity
range.
The text in the error messages depends on the set language. The error message identifier (Exx) is the same for every
language.
IMS 5x00
Chap. A 3.
Page 144