Table of Contents
Advertisement
Appendix | ASCII Communication with Controller
A 3.3.12 Select Measurement Values to be Output
A 3.3.12.1 General
Setting the values to be output via the Ethernet interface.
The maximum output rate via the Ethernet interface depends on the number of output values.
A 3.3.12.2 Data Selection of Ethernet
OUT_ETH [<signal1>] [<signal2>] ... [<signalN>]
Describes which data are output via these interfaces.
A 3.3.12.3 List of Possible Ethernet Signals
META_OUT_ETH [MEAS | VIDEO | CALC]
List of possible data for Ethernet.
The parameter Video contains the FFT signal.
Additional activation using the OUTPUT command (see Chap. A 3.3.11.1) is required.
A 3.3.12.4 List of Selected Signals, Transfer Sequence via Ethernet
GETOUTINFO_ETH
Indicates the signal sequence via these interfaces.
IMS 5x00
Page 102
Advertisement
Table of Contents
Need help?
Do you have a question about the interferoMETER and is the answer not in the manual?
Questions and answers