A 3.6 Warning And Error Messages - MICRO-EPSILON interferoMETER Operating Instructions Manual

Appendix | ASCII Communication with Controller
A 3.6 Warning and Error Messages
E200 I/O operation failed
E202 Access denied
E204 Received unsupported character
E205 Unexpected quotation mark
E210 Unknown command
E212 Command not available in current context
E214 Entered command is too long to be processed
E230 Unknown parameter
E231 Empty parameters are not allowed
E232 Wrong parameter count
E233 Command has too many parameters
E234 Wrong or unknown parameter type
E236 Value is out of range or the format is invalid
E262 Active signal transfer, please stop before
E270 No signals selected
E272 Invalid combination of signal parameters, please check measure mode and signal selection
E276 Given signal is not selected for output
E277 One or more values were unavailable. Please check output signal selection
E281 Not enough memory available
E282 Unknown output signal
E283 Output signal is unavailable with the current configuration
E284 No configuration entry was found for the given signal
E285 Name is too long
E286 Names must begin with an alphabetic character, and be 2 to 15 characters long. Permitted characters are:
a-zA-Z0-9_
E320 Wrong info-data of the update
E321 Update file is too large
E322 Error during data transmission of the update
E323 Timeout during the update
E324 File is not valid for this sensor
E325 Invalid file type
E327 Invalid checksum
E331 Validation of import file failed
E332 Error during import
E333 No overwrite during import allowed
E340 Too many output values for RS422 selected
E350 The new passwords are not identical
E351 No password given
E360 Name already exists or not allowed
E361 Name begins or ends with spaces or is empty
E362 Storage region is full
E363 Setting name not found
IMS 5x00 Page 110