Basic Qos Settings - NetComm NP740n User Manual

3-1-1 Basic QoS Settings

Please follow the following instructions to set QoS parameters:
Please click 'Qos' menu on the left of web management interface and the following message will be displayed
on your web browser:
Here are descriptions of every settings:
Enable QoS: Check this box to enable QoS function, unselect this box if you don't want to enforce QoS bandwidth
limitations.
Total Download
You can set the limit of total download bandwidth in kbits. To disable download bandwidth limitation,
Bandwidth: input '0' here.
Total Upload
You can set the limit of total upload bandwidth in kbits. To disable upload bandwidth limitation, input
Bandwidth:
'0' here.
Current QoS Table: All existing QoS rules will be displayed here.
Add: Click 'add' button to add a new QoS rule, see section 3-1-2 'Add a new QoS rule' below.
Edit:
If you want to modify the content of a specific rule, please check the 'select' box of the rule you want
to edit, then click 'Edit' button. Only one rule should be selected a time! If you didn't select a rule
before clicking 'Edit' button, you'll be prompted to add a new rule.
Delete Selected:
You can delete selected rules by clicking this button. You can select one or more rules to delete by
check the 'select' the box of the rule(s) you want to delete a time. If the QoS table is empty, this button
will be grayed out and can not be clicked.
Delete All:
By clicking this button, you can delete all rules currently in the QoS table. If the QoS table is empty,
this button will be grayed out and can not be clicked.
Move Up:
You can pull up the priority of the QoS rule you selected by clicking this button.
Move Down:
You can lower the priority of the QoS rule you selected by clicking this button.
Reset:
If you want to erase all values you just entered. Click 'Reset'.
After you finish with all settings, please click 'Apply' button, and the following message will be displayed on
your web browser:
Please click 'Continue' to back to previous setup menu; to continue on other setup procedures, or click 'Apply'
to reboot the router so the settings will take effect (Please wait for about 50 seconds while router is rebooting).
If you want to reset all settings in this page back to previously-saved value, please click 'Cancel' button.
NP740N 11n Wireless Router
8
YML887
www.netcomm.com.au