N600 dual band wifi gigabit modem router (71 pages)
Summary of Contents for NetComm N300 NP804n
Page 1
Netcomm N300 Wireless Router NP804n Setup Guide 1 ‐ Plug the router into a power outlet using the power pack provided. Check that one or more lights on the front of the router are lit. 2 ‐ Ensure PC is connected to one of the LAN ports on the back of the router. 3 ‐ Open an internet browser (Internet Explorer, Firefox, etc.) 4 ‐ Type 192.168.20.1 into the address bar as shown below. 5 ‐ A pop up dialog box will prompts for username & password. Username: admin Password: admin Click ‘OK’ 6 ‐ Click Internet (on the left) then PPPoE (up the top) to arrive at the display shown above. 7 ‐ Enter Login and Password: Login: [yourusername]@fuzeconnect.net.au Password: [your password] Service Name: should be blank, except for Botany customers where it should be “service1”. 8 ‐ Click Apply. 9 – The router may reboot and may take several minutes to complete the connection. ...
Page 2
Wireless Setup 1 – Click on Wireless. 2 – Use any preferred name as SSID1. 3 – The channel that the wireless uses can be changed by selecting Disable for Auto Channel and choosing a new number from the Channel drop down menu. 4 – Click on Apply. 5 – Click on Security. 6 – Choose any preferred Pre‐shared Key (should be combination of letters and numbers). 7 – Click on Apply. ...
Page 3
Resetting router 1 – To reset the router completely, log into 192.168.20.1 2 – Click Tools (left menu). 3 – Click Back‐up (top menu). 4 – Look for “Restore to factory default” 5 – Click Reset. 6 – The router will now reset, this may take several minutes and you may need to enter the username and password to access the router again. ...
Need help?
Do you have a question about the N300 NP804n and is the answer not in the manual?
Questions and answers