NetComm NP740n User Manual page 16

Connect the router's management interface by web browser
After your computer has obtained an IP address from the router, please start your web browser, and input the
router IP address (default: 192.168.1.1) in the address bar. The following message should be shown:
Please input user name and password in the field respectively, default user name is 'admin', and default
password is 'admin', then press 'OK' button, and you can see the web management interface of this router:
NOTE: If you can't see the web management interface, and you're being prompted to input user name and password again, it means you
didn't input username and password correctly. Please retype user name and password again. If you're certain about the user name and
password you type are correct, please go to '4- Troubleshooting' to perform a factory reset, to set the password back to default value.
TIP: This page shows the four major setting categories: QuickSetup, General Setup, Status, and Tools. You can find the shortcut which
leads to these setting categories at the upper-right corner of every page, and you can jump to another category directly by clicking the
link, and don't have to go back to the first page.
NP740N 11n Wireless Router
1
YML887
www.netcomm.com.au