NetComm NP740n User Manual page 67

11n wireless broadband router

Hide thumbs Also See for NP740n:

Table of Contents

Enable IP Filtering

Check this box to enable IP address based filtering, and please select 'Deny' or 'Allow' to decide the

Table:

behavior of IP filtering table. If you select deny, all IP addresses listed in filtering table will be denied

from connecting to the network; if you select allow, only IP addresses listed in filtering table will be

able to connect to the network, and rejecting all other network devices.

IP Filtering Table:

All existing IP addresses in filtering table will be listed here.

Add PC:

Click this button to add a new IP address to IP filtering table, up to 20 IP addresses can be added.

Please refer to section 3-3-1-1 'Add PC' below.

Delete Selected:

If you want to delete a specific IP address entry, check the 'select' box of the IP address you want to

delete, then click 'Delete Selected' button. (You can select more than one IP addresses).

Delete All:

If you want to delete all IP addresses listed here, please click 'Delete All' button.

After you finish with all settings, please click 'Apply' button, and the following message will be displayed on

your web browser:

Please click 'Continue' to back to previous setup menu; to continue on other setup procedures, or click 'Apply'

to reboot the router so the settings will take effect (Please wait for about 50 seconds while router is rebooting).

If you want to reset all settings in this page back to previously-saved value, please click 'Cancel' button.

YML887

www.netcomm.com.au

NP740N 11n Wireless Router

Table of Contents