Setup Procedure For 'Ap Bridge - Wds - NetComm NP740n User Manual

11n wireless broadband router

Hide thumbs Also See for NP740n:

Table of Contents

2-7-1-4 Setup procedure for 'AP Bridge – WDS'

In this mode, you can expand the scope of network by combining up to four other access points together, and

every access point can still accept wireless clients.

Here are descriptions of every setup items:

Band

Select the band you want to use, two wireless routers must use the same setting.

ESSID

Input the ESSID of your wireless router, it can be the same with other wireless routers for the

convenience of roaming, or different with other wireless routers so you can identify each of them.

Channel Number

Select the channel you want to use, two wireless routers must use the same setting.

MAC address

Input the MAC address of other wireless routers.

1 to 4 (5 - 8)

Set Security

Click to set security settings for this connection (Please go to section '2-7-3 Wireless Security' for

detailed instructions).

After you finish the wireless setting, please click 'Apply' button, after you click 'Apply', the following message

will be displayed on your web browser:

Please click 'Continue' to back to previous setup menu; to continue on router setup, or click 'Apply' to reboot

the router so the settings will take effect (Please wait for about 50 seconds while router is rebooting).

YML887

www.netcomm.com.au

NP740N 11n Wireless Router

Table of Contents