Network Address Translation (Nat); Basic Nat Settings (Enable Or Disable Nat Function) - NetComm NP740n User Manual

11n wireless broadband router

Hide thumbs Also See for NP740n:

Table of Contents

3-2 Network Address Translation (NAT)

Network address translations solve the problem if sharing a single IP address to multiple computers. Without

NAT, all computers must be assigned with a valid Internet IP address to get connected to Internet, but Internet

service providers only provide very few IP addresses to every user. Therefore it's necessary to use NAT

technology to share a single Internet IP address to multiple computers on local network, so everyone can get

connected to Internet.

Please follow the following instructions to set NAT parameters:

Please click 'NAT' menu on the left of web management interface, and the following message will be

displayed on your web browser:

To enable NAT function, please select 'Enable' for 'Enable or disable NAT module function' ; to disable, please

select 'Disable'.

After you made the selection, please click 'Apply' button, and the following message will be displayed on your

web browser:

Please click 'Continue' to back to previous setup menu; to continue on other setup procedures, or click 'Apply'

to reboot the router so the settings will take effect (Please wait for about 50 seconds while router is rebooting).

NP740N 11n Wireless Router

YML887

www.netcomm.com.au

Table of Contents