Fbo Active Leaf #2 Installation Procedure (Track); Fbo Active Leaf #1 Installation Procedure - Assa Abloy Besam VersaMax ICU Installation Manual

Active Leaf in swung out position
Fig. A
PSA Arm
Carrier
Fig. B
Ball Catch
Fig. C
Vertical Adjustment Screw

US23-2101-02 Rev A

FBO Active Leaf #2 Installation Procedure (Track)

1. Move inner carrier, for active leaf #2, away from sidelite.
2. With the Active Leaf #2 swung out away from carrier, slide
PSA arm into carrier so that it is recessed 1/4". (See Fig. A.)
3. Swing panel in and engage pin guide into track. Adjust PSA
as required. See PSA Arm

FBO Active Leaf #1 Installation Procedure

Note!
A Breakout Cam is to be installed on active leaf #1 in all
applications where a Positive Latch or "C" Handle options are
chosen.
1. With the Breakout Cam already installed on Active Leaf #1,
move outer carrier for active leaf #1 away from other doors.
(See Fig. A.)
2. With Active Leaf #1 swung out away from carrier, slide PSA
arm into carrier. (See Fig. A.)
3. Swing panel in and engage Pin Guide into Track. Adjust PSA
as required. See PSA Arm
4. Adjust Wedge Damper to desired friction. (Damper should
hold the door in place when fully open.) (See
Adjustment Section.)
5. Breakout door and tighten the vertical adjustment screw on
the PSA arm to lift the lead edge of the door and ball catch
into alignment with the ball catch receiver. See PSA Arm
Illustration Fig. C. Slide door to the fully open position. For
additional PSA adjustment information see
Adjustments
Note!
If the glass has not been previously installed, recheck alignment
after glazing and readjust as necessary.
Issued: 9-22-2011
Adjustments.
Adjustments.
Wedge Damper
PSA Arm
Page 23