Sweep Adjustment
Counter Sunk Holes
US23-2101-02 Rev A
1. If sweep(s) are included in your package, trim to length
required for each panel.
Note!
The sweep will be longer than the sweep holder. Install sweep
and holder into bottom of door as shown.
2. Insert sweep into Sweep Holder.
3. Once doors are hung, adjust sweeps to desired height and
location and secure with hardware supplied with door.
Note!
Two counter sunk holes have been provided in the bottom of the
door for securing the sweeps. A 1/8" hole must be drilled through
each of the predrilled holes in the bottom rail into the sweep
holder, then using the two screws provided, secure the sweep.
Sweep
Issued: 9-22-2011
Sweep Holder
Page 43