Assa Abloy Besam VersaMax ICU Installation Manual page 29


US23-2101-02 Rev A
16. To adjust door height, loosen Wheel Bracket bolts & Anti-
riser bolts and adjust door to proper height using the
Adjustment Screw on the Wheel Brackets, taking into
account the floor conditions for the full travel of the doors.
When finished, tighten wheel bracket screws. (See Fig E)
Fig E
Adjustment Screw
17. Slide doors to full open position, engaging the pivot block to
the pivot pin on the floor mounted plate.
Note!
If the glass has not been previously installed, recheck ball catch
alignment after glazing and readjust as required.
Issued: 9-22-2011
Anti-riser Bolt
Wheel Bracket Bolts
Page 29