Table of Contents
Advertisement
Install Track and Arm to Right Door
A. Mount Track.
1. Using previously prepared holes in left door,
install three (3) 1/4-20 x 1-5/8" screws through
track and into sex bolts. (Figure 26)
NOTES: (Figure 27)
y Opening of track is toward top of door.
y Adjustable bumper stop is toward hinge
edge of door.
B. Install Arm Assembly To Track.
1. Open right door.
2. Using an adjustable wrench, rotate top
pinion 45 degrees toward door hinge. You
will feel resistance from spring. (Figure 28)
3. While holding pinion at 45 degrees, slide
arm on bottom pinion parallel to frame as
shown. (Figure 28)
NOTE: Pinion flat should be aligned as
shown. (Figure 29)
4. Secure arm to pinion with 1/4-20 x 1/2" screw
and countersunk patch washer. (Figure 28)
5. Insert stud on arm into slider in track by
pressing clip on backside of slider onto stud.
(Figure 30)
6. To adjust track stop:
y Use allen wrench to loosen set screw in
bumper stop.
y Open door to full open position.
y Slide bumper stop until it just touches
end of slider.
y Tighten set screw in bumper stop so
bumper will stay in position.
(Figure 31)
Bumper Stop
12
D6001DE-L Series Double Egress Power Operator Unit
Set Screw
Figure 31
Copyright © 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in part
Approved 2023-11-10
Sex Bolts
Figure 26
Track Opening
Figure 27
Arm Stud
Slide
Assembly
without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Adjustable Bumper Stop
Figure 28
Figure 29
A
B
Figure 30
80-9360-1048-020 Rev 1 01/23
Advertisement
Table of Contents
