Torsion Tube Adjustment (Large Doors) - Assa Abloy Besam VersaMax ICU Installation Manual

Torsion Tube Adjustment (Large Doors)

Page 44
The Torsion Tube aids in aligning doors to jamb and is factory
installed.
1. To adjust Torsion Tube, tighten set screws in pivot end block
and loosen set screws in breakout end block.
2. Insert pry-bar through underside of carrier between tube and
carrier wall at breakout end.
3. Apply pressure as required to position carrier as desired, and
tighten set screws.
Issued: 9-22-2011
Set Screw
Set Screw
Bottom View
Breakout End
US23-2101-02 Rev A
Torsion Block
Tube