Advertisement
Flexi -3G Installation & Commissioning Manual
Chapter 3. Installation Procedure
3.6. Securing the Power Cabinet to the Wall (if required)
For extra stability, it is possible to additionally secure the Power Cabinet to the wall, after securing it to
the Battery Cabinet.
WARNING
• The Power Cabinet is not a stand alone unit and must be mounted on top of the
Battery Cabinet before attempting to secure it to the wall.
1
Power Cabinet
1. Remove the 2 plastic push rivets securing the DC Distribution Cover Insulator to the Power Cabinet
(if fitted).
2. Remove the DC Distribution Cover Insulator from the Power Cabinet and put to one side in a safe
place (if fitted).
Page 32 of 94
Fig. 3-10 Power Cabinet
Document No: - 4493-CM-EN-10989402
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
2
DC Distribution Cover Insulator (Optional)
2
1
Advertisement
Chapters
