Control Accessories; Cabinet Ordering Accessories; Incoming Power Receptacles; Cable Locking Sleeves - Eaton COOPER POWER Series M Installation And Operation Instructions

Control accessories

These accessories are available. Contact your Eaton
representative for additional information.

Cabinet ordering accessories

ANSI 304 stainless steel cabinet construction available as an
ordering option. Refer to SPEAR Catalog CA280001EN for
ordering information.

Incoming power receptacles

The Incoming Power Receptacle allows the user to
conveniently plug the power cable into the control,
eliminating the need for hardwiring to the control. Table 11
includes the available input receptacle and cable for the
SPEAR single-phase recloser control.

Cable locking sleeves

To prevent detachment of the control cable from the control
cabinet by unauthorized personnel, a cable-locking sleeve
(Catalog Number KSPRC-1772-X [replace X with quantity:
maximum 3]) is available to enclose the cable plug. The
plug is passed through the sleeve and the sleeve is then
fastened from inside the control cabinet. There is no access
to the cable receptacle without opening the locked cabinet
door and detaching the sleeve.
Table 11 . Receptacles and wiring; input cables
Description
120 VAC or 240 VAC input receptacle, 2-pin
120 VAC or 240 VAC input receptacle, 3-pin
No input receptacle, for hard-wiring input
AC Input Cable, 120 or 240 VAC, 2-wire for 2-pin input
for use with KSPRC-1775-H receptacle.
Replace X with desired length. Select from 0 to 50 feet.
Armored (10 ft.) input cable. Replace X with desired
length. Select from 10 to 50 feet.
AC Input Cable, 120 VAC, 3-wire for 3-pin input for use
with KSPRC-1775-J receptacle.
Replace X with desired length. Select from 0 to 50 feet.
Note: To order a mating plug body only (for use with customer supplied
cable), replace "X" with length of "0".

Automation accessory packages

The SPEAR single-phase recloser control includes an
auxiliary power supply that provides a customer connection
to 13.5 VDC. This source is intended to be used to power
radios and other communications support equipment for
connection to SCADA and other remote communications
systems. The power supply is backed up by the control
batteries in the SPEAR single-phase recloser control
cabinet, and will continue to provide power to connected
accessories under loss of AC line power to the recloser
control. A maximum of 12 W continuous and 30 W peak
(intermittent) power can be delivered to accessories
connected to the auxiliary power supply.
A variety of automation packages are available to be used
in conjunction with the auxiliary power supply to facilitate
the mounting and proper connection of antennas to radios
mounted in the control cabinet. Packages are available to
support many popular radio technologies and frequency
bands. See Table 12 for details on each of the available
automation accessory packages.
N otee:
Table 12 . Automation accessory packages
Description
Wireless communication provisions package 13.5
VDC interface board, radio mounting tray (Radio and
communications interface cards not included)
Cellular communications connection and protection
package 32" SMA(m)-N(m) coax pigtail, 700MHz – 2GHz
PolyPhaser and mounting hardware, N(f)-type external
termination
WiFi/WiMax communications connection and protection
package 32" SMA(m)-N(m) coax pigtail, 2GHz – 6GHz
Polyphaser and mounting hardware, N(f)-type external
termination, TNC(m)-SMA(m) inline coaxial adapter
125MHz to 1GHz N-terminated radio connection and
protection package 25" N(m)-N(m) coax pigtail,
125MHz to 1GHz PolyPhaser and mounting hardware,
N(f)-type external termination
700MHz to 2GHz TNC-terminated radio connection
and protection package 32" TNC(m)-N(m) coax pigtail,
700MHz to 2GHz PolyPhaser and mounting hardware,
Catalog number
N(f)-type external termination
KSPRC-1775-H
PolyPhaser and mounting hardware: 125MHz – 1GHz
KSPRC-1775-J
PolyPhaser and mounting hardware: 700MHz – 2GHz
KSPRC-1775-0
PolyPhaser and mounting hardware: 2GHz – 6GHz
†
KA11ME1-X
Requires Communication Interface Option: (1) RS-232 Interface
* Requires that the KSPRC-1774-29 Wireless Communication Provisions
Package also be ordered
KA124ME-X
Note: The SPEAR control includes a 3-ft RS-232 cable with 90 degree
connector when RS-232 Communication Interface option is ordered.
KME4-67-3-X
Table 13 . Miscellaneous accessories
Description
120 VAC Battery Charger for spare batteries
INSTALLATION AND OPERATION INSTRUCTIONS MN280048EN June 2016
SPEAR™ Single-Phase Recloser System
A maximum of one automation accessory can be
ordered. KSPRC-1774-29 is not included in this
maximum.
†
Catalog number
KSPRC-1774-29
KSPRC-1774-22*
KSPRC-1774-23*
KSPRC-1774-24*
KSPRC-1774-25*
KSPRC-1774-A*
KSPRC-1774-B*
KSPRC-1774-C*
Catalog number
KME5-60-1
29