Advertisement
3.3.4. Fitting the Battery Support Strap Kit
1
4
12
5
1
Side Panel LH
5
Battery Support Strap Kit
1. On the Battery Tray second from the bottom, (if fitted), position and secure a set of two Battery Tray
Support Straps. Slot the end of the straps inside the Support Bar metalwork and hold in place with
the captive screws. The straps span the front and rear Battery Support Bars, as shown.
2. Secure the Battery Tray Support Straps with the Support Strap Fixings and tighten to 2Nm .
3. Repeat points 1 to 6 for the Battery Tray forth from the bottom, if fitted.
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
Flexi -3G Installation & Commissioning Manual
4
2
Side Panel RH
12
Screw M4x8 Captive Pozi
Fig. 3-5 Fitting the Battery Support Strap Kit
Document No: - 4493-CM-EN-10989402
Chapter 3. Installation Procedure
2
4
Battery Support Bar
Page 27 of 94
Advertisement
Chapters
