Advertisement
Flexi -3G Installation & Commissioning Manual
Chapter 3. Installation Procedure
3.3.5. Fitting the Optional Battery Cabinet Door
10
Battery Cabinet Door
1. Place the Hinge Brackets (3 off) in position against the Side Panel RH as shown.
2. Secure the Hinge Brackets to the Side Panel RH using the Screws M5x12 CSK Pozi.
3. Tighten the Screws M5x12 CSK Pozi to a torque of 2Nm.
4. With the Door at 45º to the Cabinet, align the 3 Door Hinge Slots with the Hinge Bracket Tabs on
Side Panel RH and insert, as shown.
5. With all 3 Door Hinge Slots aligned with the Hinge Bracket Tabs on Side Panel RH allow the Battery
Cabinet Door to rest on the Hinge Brackets.
6. Close Door
Warning
• DO NOT open the door beyond 90º
Page 28 of 94
11
14
11
Hinge Bracket
Fig. 3-6 Fitting the Optional Battery Cabinet Door
Document No: - 4493-CM-EN-10989402
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
10
14
Screw M5x12 CSK Pozi
Advertisement
Chapters
