Advertisement
Flexi -3G Installation & Commissioning Manual
Chapter 5. Rectifier Installation
5.2.4. Fitting Blanking Plates
Any slots in the RM10 Rectifier Magazine without rectifiers must have a Blanking
Plate fitted. This is to ensure optimum airflow through the rectifiers for cooling.
1. Place the Rectifier Blanking Plate in position on the RM10 Magazine.
2. Tighten the Blanking Plate Retaining Screw to a torque of 1.7Nm.
Procedure complete
Page 52 of 94
Document No: - 4493-CM-EN-10989402
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
Advertisement
Chapters
