Advertisement
3.3.6. Fitting the Optional Extension Kit (1150mm & 1350mm Cabinets only)
7
Side Panel Ext. RH
1. Align the tabs of the Extension Kit Side Panel with the slots in the Cabinet Side Panel, as shown.
2. Insert and lower the Extension Kit Side Panel until it is located.
3. Secure the Extension Kit Side Panels to the Cabinet Side Panels, using the Screw M5x10 PH Pozi,
Washer Plain M5 and Washer Wavy M5, as shown in 10 positions.
4. Tighten the Fixings to a torque of 2.9 Nm.
5. Put the Top Cover in position on top of the Side Panels, as shown, aligning the studs of the Top
Cover with the holes in the Side Panels.
6. Secure the Top Cover to the Side Panels, using the Washer Plain M5, Washer Wavy M5 and Nut
M5 Full Hex.
7. Tighten the Fixings to a torque of 2.9 Nm.
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
Flexi -3G Installation & Commissioning Manual
Tab Inserted into Slot
Tab
Slot
8
8
Side Panel Ext. LH
Fig. 3-7 Fitting the Optional Extension Kit
Document No: - 4493-CM-EN-10989402
Chapter 3. Installation Procedure
9
7
9
Top Cover Ext
Page 29 of 94
Advertisement
Chapters
