Fitting The Battery Support Bars - Eaton Flexi-3G Installation & Commissioning Manual

Flexi -3G Installation & Commissioning Manual
Chapter 3. Installation Procedure

3.3.3. Fitting the Battery Support Bars

4
1 Side Panel LH
4 Battery Support Bar
1. Align the tabs on a Lower Battery Support Bar with the punched slots in both of the Side Panels and
insert, as shown.
2. Push the Battery Support Bar down until it clicks into place.
3. Repeat points 1 & 2 for the other 2 Lower Battery Support Bars
4. Repeat for remaining supports referring to Table 3-1 Battery Height Accommodation on page 23
Page 26 of 94
1
2 Side Panel RH
Fig. 3-4 Fitting the Battery Support Bars
Document No: - 4493-CM-EN-10989402
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
4
3
3
Rear Panel
2