Cabling Your Multivoip - Multitech MultiVOIP 800 MVP800 Quick Start Manual

MultiVOIP Quick Start Guide

Cabling Your MultiVOIP

Cabling your MultiVOIP involves connecting the host
MultiVOIP to your LAN and telephone equipment.
If you are connecting any Voice/Fax Channel to an E&M trunk
other than type 2, perform the E&M Jumper Block Positioning
procedure, which immediately follows the Cabling Procedure,
before performing the Cabling Procedure.
1. Connect one end of the power supply to a live AC outlet
and connect the other end to the MultiVOIP as shown in
Figure 4. The power connector is a 7-pin circular DIN
connector.
Voice/Fax Channel 1 - 8
Connections
E&M
E&M
PSTN
Figure 4. Cable Connections
2. Connect the MultiVOIP to a PC by using the DB-9 to DB-25
cable provided with your unit. Plug the DB-25 end of the
cable into the Command port of the MultiVOIP and the
other end into the serial port on the PC. See Figure 4.
8
FXO FXS
FXS
FXO
Power Connection
Command Port Connection
Ethernet Connection