Table of Contents
Advertisement
Installing Your MultiVOIP 110 Software
The following installation procedures do not provide every
screen or option in the process of installing the MultiVOIP 110
software. It is assumed that a technical person with a thorough
knowledge of Windows and the software loading process is
doing the installation. Once you have installed the software,
you will be instructed on how to configure your MultiVOIP 110,
and finally, on how to deploy your MultiVOIP 110. Additional
information on the MultiVOIP 110 software is provided in the
on-line Help.
Note: The phonebook directory configuration process is
different depending on whether or not you have an enabled
H.323 Gatekeeper resident in your network. The section on
"Configuring Your MultiVOIP 110" will explain these
differences.
The MultiVOIP 110 software and User Guide are contained on
the MultiVOIP 110 CD. The CD is auto-detectable, so when
you insert it into your CD-ROM drive it will start up
automatically. When you have finished configuring your
MultiVOIP 110, you can view and print the User Guide by
clicking on the Install Manuals icon.
CAUTION: If you are installing a MultiVOIP 110 behind a
Firewall, the Firewall must support H.323. Refer to your
Firewall user documentation to enable H.323 support.
1. Make certain that your MultiVOIP 110 has been properly
cabled and that it is powered on.
2. Insert the MultiVOIP 110 CD into a CD-ROM drive. The
CD is auto-detectable, so it starts automatically. It may
take 10 to 20 seconds for the Multi-Tech Installation CD
window to appear.
Cabling
11
Advertisement
Table of Contents
