Table of Contents
Advertisement
MultiVOIP Quick Start Guide
Installing Your MultiVOIP 110
The basic steps of installing your MultiVOIP 110 network
involve unpacking the units, connecting the cables, and
configuring the units using management software (MultiVOIP
110 Configuration). This process results in a fully functional
Voice Over IP network. A brief description is provided below
with detailed instructions provided later.
Installing and Configuring Your MultiVOIP 110
The VOIP administrator must first install the MultiVOIP 110
software and then configure each MultiVOIP 110 for its specific
function. During the configuration process, it's important to
note that the Phone Directory Database is configured
differently depending on whether or not you have Gatekeeper
support on your VOIP network.
If your VOIP network supports an H.323 Gatekeeper, you
must register all H.323 endpoints with the Gatekeeper. The
procedure for doing this is explained in the section
"Registering with a Gatekeeper Phone Directory."
If your VOIP network does not have Gatekeeper software or
the Gatekeeper software is not enabled, then you must build a
proprietary phonebook with a "Host" MultiVOIP 110 and
"Client" MultiVOIP 110s. The "Host" unit includes the
assignment of a unique LAN IP address, subnet mask, and
Gateway IP address; as well as the selection of appropriate
channel interface type for each of the Voice/Fax channels.
Once all connections have been made, the VOIP administrator
configures the unit and builds the Phone Directory Database
that will reside in the Host unit.
After the "Host" MultiVOIP 110 is configured, the administrator
moves on to configure the MultiVOIP 110s designated as
"Client" units. Again, unique LAN IP addresses, subnet
masks, and Gateway IP addresses are assigned, and each
Voice/Fax channel is configured for the appropriate channel
interface type. When this is done, the Phone Directory
6
Advertisement
Table of Contents
