Cabling Your Multivoip - Multitech MultiVOIP 400 MVP400 Quick Start Manual

Cabling Your MultiVOIP

Cabling your MultiVOIPinvolves connecting the host MultiVOIP
to your LAN and telephone equipment.
If you are connecting any Voice/Fax Channel to an E&M trunk
other than type 2, perform the E&M Jumper Block Positioning
procedure, which immediately follows the Cabling Procedure,
before performing the Cabling Procedure.
1. Connect one end of the power supply to a live AC outlet
and connect the other end to the MultiVOIP as shown in
Figure 3. The power connector is a 7-pin circular DIN
connector.
PSTN
2. Connect the MultiVOIP to a PC by using the DB-9 to DB-25
cable provided with your unit. Plug the DB-25 end of the
cable into the Command port of the MultiVOIP and the
other end into the serial port on the PC. See Figure 3.
Voice/Fax Channel 1 - 8
Connections
E&M FXS
FXO
E&M FXS
FXO
Figure 3. Cable Connections
Cabling
Power Connection
Command Port Connection
Ethernet Connection
9