Table of Contents
Advertisement
Configuring the MultiVOIP
connecting to. The Interface tab defaults to Channel 1 in
the Select Channel box. To change the channel number,
click the drop-down arrow and the list of channels
displays. Highlight the channel you want to configure.
Feature options are enabled or disabled (grayed out)
according to the interface type that you select. The one
option available for all interface types is the Inter Digit
Time option. This option defines the maximum amount of
time that the unit will wait before mapping the dialed digits
to an entry in the Phone Directory Database. If too much
time elapses between digits, and the wrong numbers are
mapped, you will hear a rapid busy signal. If this happens,
it will be necessary to hang up and dial again. The default
is 2 seconds.
6. The Ring Count FXS window allows you to set the
maximum number of rings output on the FXS interface
before hanging up and releasing the line to another call.
The default setting is 8 counts.
Note: Zero (0) means no rings - caller hears a busy tone.
45
Advertisement
Table of Contents
