Remove a 4-port card
Steps
1. Remove the SFPs from the front of the embedded module.
2. Remove the air dam at the front of the embedded module by loosening the four captive screws.
3. Push down the two blue tabs on the back of the 4-port card to release the 4-port card.
Figure 54. Opening the retaining tabs
4. Lift the 4-port card off the pegs, and pull the 4-port card away from the embedded module.
Figure 55. Removing the 4-port card
Install a 4-port card
Steps
1. Align the 4-port card in the embedded module so that the ports on the front line up with the slots on the front of the
embedded module.
2. Align the white pegs beneath the holes on the 4-port card.
CAUTION:
Do not force the 4-port card into place. If the 4-port card does not smoothly seat, re-align the
pegs and try again.
Service Procedures
55