Install An Embedded Module - Dell EMC Unity All Flash Installation And Service Manual

2. Align the white pegs beneath the holes on the 4-port card.
CAUTION: Do not force the 4-port card into place. If the 4-port card does not smoothly seat, re-align the
pegs and try again.
Figure 41. Seating the 4-port card
3. Gently push down on the upper-left circle on the 4-port card.
4. Push up on the blue tabs until they lock into place.
Figure 42. Locking the 4-port card into position
5. Replace the air dam and tighten the four captive screws.
6. Install the SFPs into the embedded module.

Install an embedded module

Steps
1. Align the embedded module with the empty slot and carefully push it into the slot.
As the embedded module is installed, the release lever rotates inward.
Service Procedures 45