Remove A 4-Port Card - Dell EMC PowerStore 1000 Installation And Service Manual

Figure 41. Removing the embedded module from the system
4. Remove the embedded module from the slot.

Remove a 4-port card

Steps
1. Remove the SFPs from the front of the embedded module.
2. Push down the two blue tabs on the back of the 4-port card to release the 4-port card.
Figure 42. Opening the retaining tabs
3. Lift the 4-port card off the pegs, and pull the 4-port card away from the embedded module.
NOTE: If you are having difficulty removing the 4-port card, loosen the four captive screws that secure the air dam to
the front of the embedded module .
Base enclosure service procedures 45