Redundant Configuration Using A Two-Port Perc Adapter; Connect The Power Cables - Dell PowerVault MD2460 Owner's Manual

Figure 24. Redundant configuration using a four-port PERC H965e adapter

Redundant configuration using a two-port PERC adapter

This configuration supports two enclosures in a single chain. The PERC H840 adapter is supported only on PowerEdge 14G and
15G servers.
Figure 25. Redundant configuration using a two-port PERC H840 adapter

Connect the power cables

Before connecting to the power source, ensure that you have completed the installation process. The power supply starts up
immediately when the power cable is connected to the chassis.
Steps
1. Connect the power cables to each PSU on the back panel.
2. Secure the power cables to the PSU with the cable strap.
Connecting the enclosure 25