Furuno FAR-2107 Series Service Manual page 435

2. Connector
TB board (03P9342) Connector No.
J609 (Terminal)
J651 (2P-VH)
J652 (10P-VH)
J653 (Mini-Pin)
J654 (80P)
J601
(male: 9pin D-SUB)
J602 (10P-XH)
J603 (6P-XH)
J604 (2P-WAGO)
J605 (3P-WAGO)
J606 (3P-WAGO)
J607 (3P-WAGO)
J608 (WAGO-4P)
J610 (12P-WAGO)
J611 (5P-WAGO)
J612 (12P-WAGO)
J613 (2P-WAGO)
J614 (2P-WAGO)
J615 (5P-WAGO)
J616 (8P-NH)
J617 (8P-NH)
Input of MIX (Video Sig.,) 60 MHz IF receiving signal from TR
IF VIDEO sig.
unit
HV HV input from TX high voltage board (HV-9017)
PWR For connecting to the PWR board
MIX: (Video Sig.,) 60 MHz IF receiving signal inputted into the
SPU
SPU board (1.5 D co-axial cable)
SPU For connecting to the SPU board
- Program updating port of RS-232C type
PC
- ON/OFF switching of Shuttle Ferry function
For connecting control unit (RCU-014) or RCU-015. Not
KEY
connectable to RCU-016 because it has no power switch.
Connector to be used when GC-10 is incorporated
GC-10
(HDG setting is made in [HDG] -> AD-10)
Used with FAR-2x37S and connected to PSU-007 by antenna
PSU ON/OFF signal and turns on and off the antenna motor power
supply line by relay
Heading data input from IEC61162-1 and 2 types. Supports a
range between 4800 bps to 38.4 kbps according to input data
HEADING
speed and automatically switched (HDG setting is made in
[HDG] -> Serial)
Connector to navigator system of IEC61162-1 and 2 types.
NAVIGATOR Supports a range between 4800 bps to 38.4 kbps according to
input data speed and automatically switched
For connecting to log serial signal of IEC61162-1 and 2 types.
LOG Supports a range between 4800 bps to 38.4 kbps according to
input data speed and automatically switched
AD Heading data input in AD format. Set the input interval to 25
CONVERTER msec. (HDG setting is made in [HDG] -> AD-10)
SCANNER Connected to the scanner unit
AIS AIS connection connector of IEC61162-2 type
Four alarm output ports. Contact signal by MOS-FET contact.
EXT. ALARM Polarity of ALM 4 is opposite to that of other ports.
Sys Fail x1 and EXT ALM Ack should be inputted.
SCANNER Connected to the TR unit by TX HV
CARD I/F +12 VDC power supply output of CARD I/F (CU-200)
Power supply output for DVI I/F and RGB Buff boards (+12 V,
OPTION
+5 V and –12 V)
Connector for Video, HD, B.P and Trig input signals from
MASTER Radar
master radar
Connector for Video, HD, B.P and Trigger output signals from
SUB DISPLAY-1
this radar. Video signal is in FULL-LOG.
Table 7.3.1(1/2) Connector on the TB board
Overview
7-30
7.3 Processor Unit (RPU-013)