Furuno FAR-2107 Series Service Manual page 402

5. [8. WR SETTING DATA]
Item
Range Range setting value in [Range] box
Setting value of presentation mode in
Disp mode
[PRESENTATION MODE] box menu.
Function [PICTURE] -> 1 to 9
PI Setting display of index line
- Brilliance setting value in [Brill] box
Brill menu
- [BRILL] VR setting value
EBL EBL setting y
Gain [GAIN] VR setting
AC SEA Manual setting value by [A/C SEA] VR
AC AUTO Auto setting value by A/C SEA
AC RAIN Manual setting value by [A/C RAIN] VR
Manual and auto tune setting value in
TUNE
[TUNE] box.
Set Drift [Speed] box menu -> 3
Setting range of guard zone in [GZ1] and
Guard
[GZ2] box menu.
Setting range of guard alarm zone in
Guard Alarm
[ALARM1] and [ALARM2] boxes menu.
Trail Setting value of [Trail]
VRM Setting value of [VRM1], and [VRM2]
ARPA Setting value of [ARP]
AIS Setting value of [AIS]
Vector Setting value of [VECTOR]
Past Setting value of [PAST POSN]
ARPA CPA Setting value of [CPA]
ARPA TCPA Setting value of [TCPA LIMI]
Mark Setting value of [Mark]
SUB Monitor [ANT] box menu -> 8
INTSW Priority [ANT] box menu -> 9
Echo [Menu] -> 1 -> 2, 6
Mark [Menu] -> 2 -> 4, 5, 6, 7, 9, 0
(File name: Sxxxxxxx)
Table 6.6.1 Items to be Saved in WR SETTING DATA
Contents to be saved
6-46
6.6 Saving to Card I/F Unit: CU-200
Remarks
0.125 to 48 NM
HEAD UP RT to NORTH UPTM
3. Setting value of Set drift
0.5NM to 20NM
1M to 60M
8. SUB MONITOR
9. INTSW Priority
2. 2ND echo REJ , 6. Wiper
4. Index line bearing,
5. Index line
6. Index line mode
Note
7. [INS MARK]
9: [EBL, VRM, CURSOR SET]
0: RING
Note:
7. To display [INS MARK],
make the setting of "[Menu]
-> 0 -> 8 -> 5: INS" to other
than "OFF".
Remark:
8: EBL OFFSET BASE is not
saved.