Furuno FAR-2107 Series Service Manual page 138

1.1 Overview
1) The system consists of a Processor unit, Monitor unit, Control unit and
Transceiver/Antenna unit. Communication between Transceiver/Antenna unit and
Processor unit, and Control unit by means of serial data (RS-422)
2) The ARPA and the Video plotter functions are incorporated in the SPU board as
standard.
3) The ARPA can acquire a maximum of 100 targets, and AIS can handle a maximum of
1,000 targets.
4) The video signal for display complies with the DVI (Digital Visual Interface)
standard.
5) The system also has Inter-switch function using the LAN.
6) The antenna cable is a new type RW9600 (13C+2C2V), and the previous type
(24C+2C2V) is not compatible.
7) The I/O terminal block is assembled on the TB board in the Processor unit.
8) Other than the Antenna radiators are not compatible with existing radar systems.
Antenna unit
LAN: 100 Base-T
RPU-013
(Processor unit)
Model
FAR-2137S
FAR-2837S
FAR-2837SW
FAR-2827W
FAR-2137S-BB
FAR-2117/2127
FAR-2117/2127-BB
FAR-2817/2827
Chapter 1. Configuration
HUB-100
(HUB)
RPU-013
(Processor unit)
Fig. 1.1.1 Example of System Configuration
Display Unit Band
20.1 inch S-band
23.1 inch S-band
23.1 inch S-band
23.1 inch X-band
S-band
20.1 inch X-band
X-band
23.1 inch X-band
1-1
MU-201CR (20.1 inch)
MU-231CR (23.1 inch)
(Monitor unit)
Antenna unit
RCU-014
(STD CONT unit)
Table 1.1.1 System Overview
Transmission
Output
30 kW 2 unit type TR up
30 kW 2 unit type TR up
30 kW 3 unit type TR down
25 kW 3 unit type TR down
30 kW 2 unit type TR up
10/25 kW 2 unit type TR up
10/25 kW 2 unit type TR up
10/25 kW 2 unit type TR up
1.1 Overview
RCU-016
(Remote CONT unit)
Remarks