Furuno FAR-2107 Series Service Manual page 317

The setting of TTM OUTPUT and INS shown in the Table below is for running TTM
data over the LAN. It is not the setting for sharing NAV data.
[OS POSN] -> 1. NAV AID
(GPS1/GPS2/LAN/INS)
[OS POSN] ->
3.SIO DATA LAN OUTPUT
[INITIALIZE] ->6 -> 2.TTM
(OFF/REL/TRUE)
[INITIALIZE] -> 8 -> 5 INS
(OFF/SRIAL/LAN)
Note:
When inputting the POS data from INS to radars, set NAV AID setting to the INS in the
respective radars.
3. Sharing NAV data with No.x radar from INS and with No.2 radar from No.1 radar
This setting assumes that NAV data is outputted from INS through the LAN port.
No.x FAR-
HDG data
xx.xx.xxx S
xxx.xx.xxx E
NAV(L/L, SPD) data
No.1 FAR-
HDG data
xx.xx.xxx S
xxx.xx.xxx E
Setting
(ON/OFF)
OUTPUT
LAN
NAV data
LAN
NAV data
Fig. 4.9.3 Example of LAN Connection-3
4.9 Selection of NAV DATA Input: [OS POSN]
Table 4.9.5 Sharing NAV Data via INS-2
No.1 No.2
(NAV Rx) (NAV Rx)
Note
INS INS
OFF OFF
Select Select
REL or TRUE REL or TRUE
LAN LAN
LAN
INS
(ECDIS)
LAN
No.2 FAR-
xx.xx.xxx S
xxx.xx.xxx E
4-53
No.x
(NAV Rx)
Note Note
INS
OFF
Select
REL or TRUE
LAN
NAV(L/L, SPD) data
HDG data
ECDIS
Input the HDG/NAV data.
HDG data
FAR
Input the HDG data for each
radar.