Furuno FAR-2107 Series Service Manual page 117

(Quoted from FQ3-2008-013 note)----------------------------------------------------
Note:
(1) RFC program cannot be updated through the LAN port.
(2) To use the LAN port on SPU boards –33 and before for software update, SPU program is
updated to V02.43 with the mini program card.
Program Name
ARPA CPU
DRAW CPU
MAIN CPU
FPGA
C-MAP MAIN CPU
1. Connect the PC to the processor unit, RPU-013 via a Hub with LAN cables.
2. Set IP address of the LAN port on the PC to 172.31.3.100 and Subnet mask to 255.255.0.0.
3. Click the "bat" file
4. Turn on the radar, FAR-2xx7 and wait for a while so that the following display is shown on the
PC screen. The update is executed automatically.
5. Wait until the "finish upload program. (size=xxxxxxx)" message appears.
-------------------------------------------------------------------------------------------------------
Bat file for Serial port
Uparpa.bat
Updraw.bat
Upmain.bat
Upfpga.bat
N/A
Bat file for LAN port
setuparpa.bat
setupdraw.bat
setupmain.bat
setupfpga.bat
setupmainc.bat
3/4